Hi GUYZ,
I have a Lionel ZWC 6-32930 and the digital display 6-14002, powered each channel with a 180 watt brick. Both work great no problems. The question I have is I use it for all my lights and accessories on the layout. Right now every time I run trains I adjust the ZWC to 10 volts per channel for the lights and accessories on all four channels, by turning the handles. Is there any problems that can happen if I would let the handles at 10 volts and just turn off the power? Then when I power it up again it would be at 10 volts when I hit the switch. Would this do any harm inside or should I continue bringing up each channel to 10 volts by hand? It’s not a big deal doing it by hand but I always had this question in my mind. Thanks for your time.
