Skip to main content

1 reply

MTH PS3 boiler board pinouts

D DashingDanLIRROGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

Hi all,

Does anyone know what pin 8 does on the boiler board?

I got a used MTH 20-3401-1 that has wiring issues (engine speed is inconsistent, does'nt listen to commands, etc.) needless to say i believe I found a short, the drawbar pin off the harness was connected to pin 8, when I believe it should be connected to pin 3 on the 8 pin connector.

Needless to say I can't figure out what pin 8 is actually supposed to be used for.



Thanks,

Dan

Original Post

Add Reply

Tags: MTH, PS3, pinouts, boiler, board
Views: 115
Post
The DCS Forum is sponsored by

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×