So some really good people on the layout forum were able to help me develop a track plan and now I have to get some electrical going for the new layout. I have one 20 amp breaker that will be dedicated for the train and I am wondering if one outlet with a power strip or two is good enough or should I add a few outlets around the layout. My plan is to run DCS with a TIU, 2 AIU's and a WIU. My main power supply is a Z-4000 and 4 MTH AC power bricks.
Replies sorted oldest to newest
One outlet should be sufficient for your power needs. I run Legacy using four 180 Powerhouses plus the Legacy base. This all is on one outlet to good quality power strip from a 20 amp breaker.
Ray
I vaguely recall some threads here (but may be many DCS versions removed) about power strips causing interference with some command operations. Might want to check that out before deciding to go with only one outlet. Even if power strips are not a problem, why not wire the area for other potential uses while doing the work? Also, don't forget layout lighting in ceiling or higher up on walls.
Chuck
A 20 A circuit is more than adequate. A good power strip or two will be required to plug all of that stuff in. Spend a couple bucks to get high quality strips with good surge suppression built in. I would also recommend a master switch to kill the power to the layout, or at least place the power strips where you can reach them.
Access to this requires an OGR Forum Supporting Membership
