Skip to main content

Hey all..   upgrading my 612 J steam... can you use the tach reader from the ps2 5 volt on the ps3? I  noticed the spacer is too tall and it touches the flywheel...  the wires are the same color and position.. they look identical...    i figure i can solder the ps3 harness to the reader.  

Original Post

Replies sorted oldest to newest

Its the PS3 full steam kit with speaker and wiring and the bits.  (Board is in tender) Teather to engine. 

 The Tach reader shim on the PS3 harness is too tall. Rather than unsolder the 4 points and try to remove that plastic shim, shave it down to correct thickness for the Airgap to the Flywheel, I though I would just use the PS2 Tach that is already there.  I can show some pictures of what im talking about later.     am I making sense? 

Thanks 

Chris

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×