Skip to main content

Hi Everyone,

 

I assume this an electrical area. I received a Z-stuff signal bridge. I jitd wiring the hot and common to a terminal block

and powering the TB with a Z500 brick. The lights on the bridge are suppose to turn all green when first powering up

however; my unit is going to red. According to the instructions a factory calibration might have to be done.

You are suppose to take all the input wires from the unit and connect them to power and a reset is suppose to occur

when the lights star blinking. In my case I get no power at  all when connecting all the wires..

 I left a phone message for Z-suff. The unit is very well made and great looking.

Anyone have any idea what the issue is?

 

Thanks

 

Trackahead

 

Original Post
Post
×
×
×
×
Link copied to your clipboard.
×
×