Skip to main content

2 replies

Wiring MTH ITAD, Dallee Flasher and Lionel 154 Crossing

cbojanowercbojanowerOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBERMEMORIAL SUPPORTER

I had this wired with a Lionel IR Sensor but I am now trying to wire this  with the MTH ITAD, but am missing something .

Here is the directions for the Dallee flasher

Here are the directions for the MTH ITAD

 

I am trying to set this flasher up as shown in the section of the Dallee directions for "Wiring 3-Rail Track for Automatic Operation" substituting the ITAD for the insulated rail

On the ITAD there aew 5 terminals NO, NC, COM, AUX + and -. I have run AUX + and - to the 12v accessory output of the transformer. This leaves me the NO and the COM terminals to connect. (The NC is not used)

So where would the NO and COM wire connect to?

 

 

Original Post

Replies sorted oldest to newest

rrmanrrmanOGR Forum Member

Hi Chris,

You run the AC common into the ITAD COM terminal.  You run a wire from the ITAD NO terminal to the DALLEE flasher Common (+) termial and to the crossbuck crossing flasher common (ground) terminal.  Check that the crossbuck common terminal is indeed common, usually its connected onto metal base with no wires, while other two terminals have wires. No damage done if misconnected other than wrong flashing.

 

The ITAD COM and NO terminals take place of insulated section and provide same circuit closure that train wheels provide from grounded common rail to the insulated rail.

Add Reply

Views: 328
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×