Skip to main content

I have an SD70 I want to upload a ps3 file in, but I really do not like clip 3 "beep-beep-beep".

I deleted clip 3 and played the entire file.  It played.

Question is?  If I upload this modified sound file will it run?  I realize I can add another clip3 , possibly from an ES44AC?

Has anyone done this?

bruce

Original Post

Replies sorted oldest to newest

Well - I uploaded that modified file, where I deleted clip 3, and it starts up, smoke, sounds, couplers, ditch lights, etc. work fine - BUT - after running for less than 1 minute she shuts down.  I have to disconnect power, remove engine from track and replace on track prior to starting up again.  She runs for maybe 2 minutes, then does the same thing.  If I do not remove from the track, whether on test track or layout, I get the message "Engine not on track".  This is in DCS mode.  In conventional, she starts up in about 20-30 seconds, sounds, etc. good.  When applying the throttle to move it shuts down, same thing.

I don't think this SD70 likes the modified file.  Tomorrow I will upload a normal SD70 file and see what happens.  She ran fine with the test file loaded.  The engine is a 20-2377-1, that was upgraded to PS3 in November 2016.

This is the second PS3 Diesel Upgrade I have completed.  The other was done in December 2016 and runs fine.

bruce

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×