Skip to main content

I came across this idea when I attempted to bend Atlas track into transitional curves What happene was the track sprung all over the place. But that got me to thinking. Perhaps some of you have already tried this.I turned the track over and cut the tabs that are  molded to the ties about every 4th tie. Then I started the bend and what a beautiful bend it did. This method sure sav.es cutting and fitting enormous anount of preformed curve track which is quite expensive. For those who havent tried it give it a try.

Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×