I have a set of TMCC shark nose engines. Trying to save nudge settings using cab-2 remote. Is it possible?
Original Post
Replies sorted oldest to newest
The only "nudge" setting I know of is the feature of the ERR Cruise Commander or Cruise Commander M boards. If these are stock TMCC engines, they don't have the feature.
Are you talking about the stall speed setting that is used for Pulmore motor equipped engines?
Yes
Yes what?
Yes stall speed sitting. Trying to get them running at the same speed. I can adjust the speed on one or the other but I can’t figure out how to save the sitting. I only have cab-2 remote.
Attachments
Images (1)
When you press the SET to save the setting, it's saved in the locomotive until you change it. You just then run the other one and do the same thing.
I believe I tried that but I will verify it and let you know. Thanks
Sorry for getting back to so late I apologize. I never was able to get them to run at the same speed. Do you know of anyone who I could send them too to fix the problem. I don’t have a lot of experience and what makes things worse I have no patience Lol
I was never able to use the nudge feature with a cab 2 remote. I think it's because the boost/brake button is a rocker switch and not actual buttons.
Do you have any suggestions how to fix the problem
If you have, or know someone who has a Cab 1 remote you might be able to set the nudge feature. If you look at a Cab 1 remote it has actual boost/brake buttons which if when set and the engines hold the settings that might do it.
I gave up trying to use a Cab 2 remote to set the nudge feature.
Thank you
The brake/boost feature on the CAB2 that is combined with the direction button sends the exact same codes to an engine configured as TMCC as the CAB1 or CAB1L would send.
Perhaps you could share the actual product number of the engines you're working with?
