Can I run the MTH 30-11030 PRR signal bridge on DC voltage?

I downloaded the PDF for this product from MTH.  Funny enough, it doesn't specify AC or DC.

Can someone please help?

Thanks,

George

I run mine off my Z4000 accessory port and it works great.

If it is just light bulbs, then yes , no problem.

I run MTH crossing gates, highway crossing signals, all my buildings, traffic signals. and cantilever signal with 12 vdc from a computer power supply. Why not just try it?

@John H posted:

I run MTH crossing gates, highway crossing signals, all my buildings, traffic signals. and cantilever signal with 12 vdc from a computer power supply. Why not just try it?

John,

Thank you very much for the information.  I do use a 12vdc regulated switching power supply (not from computer) for lights, buildings, other signals, and a lot of other devices.  I suspected the signal bridge would work on DC power, but was unwilling to just try this because this accessory costs $80 these days.  And I have 2 of them already installed on the layout in tight and / or inconvenient spots.

However, your information was very useful - thank you.

George

George, If you give this a try, will you post your result?  Thanks,

Bob

@Bob Golfs posted:

George, If you give this a try, will you post your result?  Thanks,

Bob

Absolutely.  You'll read about it in the Panhandle thread.  It's always been my practice to report everything - the good, the bad, and the ugly.

George