I'm wondering how complicated it is to wire operating accessories for both legacy cab 2 operation through the ASC2 and keeping the toggle switches as well? I would like to keep the manual/original operating switches for the accessories for little ones and me to operate. However I would also like to be able to operate using a cab 2 remote in the future. Can both operate in tandem? Some are toggles, some are momentary switches.
Thank you for the help!
Replies sorted oldest to newest
No problem, just wire them in parallel. The ASC2 switch function is momentary, it's like it's not there if it's not activated.
Ok perfect. I wanted to make sure I wasn’t overlooking something.
Thank you!
I overestimated my understanding haha. I drew this out but I'm having a hard time understanding how to wire the switch to work with this. Or do I need a three way type switch? Because with a normal switch I can't wire after the ASC2 controller because that circuit is normally open so no power would come from it unless the ASC2 is active/closed. But if I wire the switch from the distribution I could "accidentally" put power to the accessory from both the switch and the ASC2. Thanks again for the help.
Putting power from both the ASC and the manual switch isn't a problem, it just gives the power a parallel path. Obviously, if both are on, you REALLY want the accessory to run! 
Ok got it. Thank you!!
Access to this requires an OGR Forum Supporting Membership
