Skip to main content

I purchased a Lionel command control inspection car - powered track as usual and tried to address as EN 1 on Legacy remote, but it just sat there with lights on. Is there something wrong with the car or do I have to re-configure the Legacy remote - if so, how do you do this? I have my original TMCC remote packed away somewhere, so if necessary I can dig that out and try it with that.

Thanks.

Original Post

Replies sorted oldest to newest

I had pressed info before but didn't see Cab 1 - tried it again and found it at the bottom left of the screen after I scrolled. It then asked me to assign it to TMCC or Legacy, chose TMCC, and then it asked me about sound version, pressed "no sounds", and then it asked me to assign a name. Named it "CAR." Finally, turned dial and it growled some, and finally moved! I don't know if the growling when starting out is normal or not? Hopefully, nothing is binding inside the car.

Thanks, again, John.

From a occasional train operator I have to say this system leaves something to be desired. Like DCS, I hope it gets more familiar as time goes on. One control system would be nice, though.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×