Skip to main content

I'm trying for the 1 st time in my O Scale life,with frustration,to set up my DCS System.

I'm 2 rail & am told to connect the Z 1,000 power brick to a "Barrel Jack," leaving off the actual transformer itself-ok that was no problem.

Next,the DCS instructions say to connect the red & black connections to the Fixed DCS IN terminals-here is where it gets ugly. The 2 male plugs look like they should fit right into the female connections on the DCS but for the life of me I've tried everything imaginable & they just loosely hang in the female ends. What's wrong? I have barrel jack 50-1017,as instructed.

Please help&thank you in advance.

Al Hummel 

Original Post

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×