I just received a pair of Tunnel Portals and side Wings from Scenic Express and I'am not sure what to use to cut or trim the material that they are made of? Any help would be appreciated.
Original Post
Replies sorted oldest to newest
Stephen,
The Scenic Express foam portals and walls can be cut with a sharp utility knife or a fine-tooth, Zona-type, wide blade razor saw.
Jim
I used my table saw to lower the tunnel portals. Made them into a stone bridge over a stream.
Thank you guys. Their double portals and are pricey. I don't wont to screw them up….
clem, that sounds good do have any photos?…..
I used a band saw, not a table saw, but I think one or the other is best if you have one. It will be smoother and there is much less chance of breaking it.
Originally Posted by Stephen C. Puntar:
Thank you guys. Their double portals and are pricey. I don't wont to screw them up…. clem, that sounds good do have any photos?…..
Sorry no photos that was on an old layout and didn't take a photo
Clem
I would use a band saw if you have one. Otherwise a razor knife with work fine as well.
Art
Art
