Can anyone tell me how to move an engine that sets itself up at position 1 on the controller to another spot? I once knew how its done but have since forgotten. I seem to recall its better to leave position 1 empty...
Thanks
Joe
Original Post
Replies sorted oldest to newest
Joe,
Menu/System/Engine Setup/Edit Engine/Edit Engine Addresss, select the new address and press the thumbwheel.
This and a whole lot more is all in MTH’s “The DCS O Gauge Companion 2nd Edition", available for purchase as an eBook or a printed book at MTH's web store!
Good morning
Is it still Taboo for position#1
Clem
Clem,
Is it still Taboo for position#1
No and it never was. Another DCS "urban legend".
Originally Posted by Barry Broskowitz:
Joe,
Menu/System/Engine Setup/Edit Engine/Edit Engine Addresss, select the new address and press the thumbwheel.
This and a whole lot more is all in MTH’s “The DCS O Gauge Companion 2nd Edition", available for purchase as an eBook or a printed book at MTH's web store!
Thanks Barry
Joe
Gentlemen,
As Barry indicates it's urban legend at it's best, have used the #1 slot sense purchasing my 1st DCS, way back when my TIU had no fuse.
PCRR/Dave
I always move engines to the last 2 digits of the Cab #.
Thankfully, So far no issues with duplicate numbers.
This Leaves #1 open for ... A NEW engine. Then I move it as well.
