Skip to main content

2 replies

DCS question for my Christmas Layout

RailrunninRailrunninOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

1000005683Good Sunday afternoon all. Please excuse the naivete of this question as it has been awhile since I've wired anything up.

My Christmas layout has one outside loop of lighted Lionel fastrack and two independent loops of o tubular on each side of where the tree will be placed.

My question is this: I have the outer loop on DCS via fixed 1. Can I run another set of wires from the same TIU output to the small oval on the left side of the picture to enable another MTH DCS engine on that small loop? Wiring is not my forte and any input is appreciated.

The small oval on the right side is powered by the other handle on the Z4000.

Thank you. Paul1000005682

Attachments

Hide
Images (2)
  • 1000005683
  • 1000005682
Last edited by Railrunnin
Original Post

Replies sorted oldest to newest

SW Steve WOGR Forum Member DIGITAL SUBSCRIBER

Three separate channels would make trouble shooting easier.  On the other hand, these are small loops, I think you could use either method.

Meaning if you decide to put them them all on one output and if you end up having issues you could disconnect the tracks one by one or you can always switch to 3 separate channels if needed.

Add Reply

Views: 95
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×