Skip to main content

Hello, so I purchased 2 new MTH GP40's from a local hobby store and I've had nothing but communication problems since I brought them home.  Ran both of them at the store and they ran fine, but when I put them in my DCS remote issues started when one didn't have sounds.  Did a factory reset and that issue was fixed, so I put them into a lash-up and they act possessed.  I put power to my layout and one of them starts up before I even turn my remote on, they don't communicate with each other at.  Occasionally the sounds cut out and are replaced with a high pitch screech from the trailing engine.  So I'm out of thoughts on this other than Factory resets and deleting and readding the engines.

Original Post

Replies sorted oldest to newest

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×