Skip to main content

I am in the process of wiring my Fastrack switches for direct power. In the instructions it says that I need to attache both a hot wire and a ground wire to the switch aux in and ground terminal. On the Lionel video it shows just to put the hot wire to the bottom of the switch and does not show a ground wire being installed which then implies that the outside rail will supply the ground. Am I correct that I do not need to attache a ground wire to the switch. Also I am planning to us 18 gauge speaker wire for the hot wire in that I have a lot of that left over from a previous project. Is that an acceptable wire to use?

Original Post

You are correct in thinking no separate ground wire is needed. The ground terminal on the Fastrack switch is connected internally to the outside rails. There is another terminal labeled "track jumper" which is connected internally to the center (power) rails. I take advantage of these terminals and install drops to my main track power/ground buss. 18ga is fine because fastback switch motors take very little current to actuate. Looking under the hood you would find a tiny DC motor.

Lew

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×