Reading the instruction sheet for the uncoupler it says 18 volts. I have Z4000's. Will they work off the accessory side at 13 or 14 volts. Any help greatly appreciated. Thanks............Paul
Original Post
Replies sorted oldest to newest
Don't see why not. I run mine off the accessory output on a Z1000.
Gilly
Thanks Gilly. I was not sure if there was a minimum amount of voltage for the magnet to work..................Paul
I believe 18 volts is the Max. voltage you can safely use with these.
Uncle Al
Per the Gargraves Uncoupling Section Instructions,
1)"Connect the two stripped leads to a 14 to 18 volt AC power source."
2)"Note: Do not apply power to this magnet for more tha a few seconds at a time
to avoid overheating the magnet."
If cars do not uncouple at maximum 18 volts AC, check the couplers, distance from uncoupler thumbtack/machined stem diecast trucks should be parallel to and inline with the center of the track and uncoupler, if no uncoupling, check the centering of the knuckle and coupler housing, broken springs plastic tang or spring, will prevent the knuckle from opening. I corrected a number of car couplers, they operate generally between 14 and 16 volts AC.
