How do you wire K-Line Supersnap 0-31 switches to operate in Lionel TMCC with the SC2 Controller?

I have 2 item for you to look at to get you wired up.

K-Line SuperSnap switches operated by TMCC | O Gauge Railroading On Line Forum (ogaugerr.com)

and SC2 Lionel manual.

60607229802501.pdf (lionelsupport.com)

Good luck.

Phillip

Phillip, thank you very much for following up. I do see on page 11 of the SC-2 manual instructions for Installation with High Rail Switch Motors. I will wire things according to this and post the results. CMac

I have wired the Supersnap switches to the TMCC SC-2 following the instructions for Lionel 022 switches, used the wall wart to power the SC-2 and all switches throw per Cab1 command, switch lights (red, green) illuminate and anti derailing feature works. a bit puzzled as the SC-2 instruction manual recommends against using the wall wart to power the SC-2 when used for switches, though though everything works fine and nothing is shorting or smoking. Thank you Phllip and John for guidance.