The TVS would be about 0.50 for each loco, and it could be run anywhere.
@ADCX Rob posted:The TVS would be about 0.50 for each loco, and it could be run anywhere.
Rob:
I’m not much of an electronics guy. What’s involved in adding this TVS?
Curt
Every bit of electrical advice that Rob has given me over the past 4 months has been 100% correct! Short, crisp, totally factual, and not mere "opinions" as are often dispensed.
Mannyrock
@Matt_GNo27 posted:Interesting. The Williams/WBB F3 uses, as I understand it, the postwar Lionel mold, and is listed as being suited for 27" diameter curves.
I’m currently looking at a Williams Hudson 4-6-4 steamer, listed as O27 scale. Will this run on both the O27 curves and the Lionel O27 (remote 5121/5122) switches? Anyone know if the loco and tender will both clear the switches? Like others on this thread my layout is all O27, and I’m running conventional. Note I do have a Williams GP9 and it clears the switches fine. Looking for a good pulling steamer that will work on my layout.
