Legacy Cab II no response!

I think it's time to call Lionel.  I don't know what else you're going to do...

Thanks John. 

I'll get back to the Forum once I hear from Lionel and their solution.

Thanks

Very little more you can do, it certainly sounds like it's dead.

Anthony,

   Pop a battery from the Cab 2, reinstall it and see it the Cab2 comes back up, right now this is what I am doing to get mine back up each time, I also need to send mine in for repair.  Darn shame this stuff is not right NIB.

PCRR/Dave

Dave, did you read this?

Installed standard alkaline batteries (fully charged) but again nothing.

Guns,

   Yes and after sitting for a short time my Cab2 will shut down and I must pop a battery to regenerate it, thought his might be doing the same thing. 

PCRR/Dave

If it's doing that, it's defective.  I have three of them, none have any issues like that.  That's certainly not normal operation.

Thanks guys for the follow through.

  Just an FYI --- Lionel could not fix the Cab2 but I received a replacement at no cost.  Thanks Lionel!!!!!   I had this equipment for at least 5 years.  Also. the technician did note that a fuse was replaced in the base.  Later this week I am going to reach out to the tech and would like to know what may have caused this unit to fail.

Thanks

Guns,

   No doubt about it mine will be going back in for repair when the layout comes down sometime later this month.  Want to test a couple of Transformers that I just picked up, before I dismantle the Christmas layout until Thanksgiving time.  I want to get the 264 up to you for upgrade also.

PCRR/Dave