Skip to main content

Just picked up this nifty chooch at York.  Runs well but exhibits some high speed

shimmy, especially on the short hood end at speeds above say 55 SMPH.  The old

stand- by way to get rid of this was to keep replacing wheels and axles 'til you get

rid of the issue.  Not sure if there is a better way to approach this problem today,

or not.  Would prefer to keep the piece as close to original as possible, but if

there's no way to do it, I'll have to swap in a set of Sam trucks and motors. Your

thoughts there, hive mind?????  Wobbling, especially in a FM is NOT allowed !!!

Original Post
Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×