I was getting ready to run my NW2 when the truck came disconnected from the drive shaft. Are there any screws that connect the truck to the frame or is it just the drive shaft? I've got it back together but it's not secure.
Replies sorted oldest to newest
Is this a new Legacy model? If it is, the trucks usually rotate 90 degrees in one direction and you can pull them off. Maybe that happened here. No screws are used for easy maintenance. Just turn the truck, realign the drive, and twist it 90 degrees. I will post a pic in a little while of it done on an SD60E...
Just make sure you don’t turn the wheels, otherwise it is hard to light the female ball joint and up with the drive in the truck.
NS6770Fan posted:Is this a new Legacy model? If it is, the trucks usually rotate 90 degrees in one direction and you can pull them off. Maybe that happened here. No screws are used for easy maintenance. Just turn the truck, realign the drive, and twist it 90 degrees. I will post a pic in a little while of it done on an SD60E...
Yes it is but the drive train is compressed of the motor in the fuel tank and a pair of drive shafts that go to each truck.
Thanks, I fixed it. One of the screws that holds the truck on came out and was sitting on my track. Not sure how that happened.
Access to this requires an OGR Forum Supporting Membership
