Skip to main content

Was wandering if I could get some feedback on my issue. Running it on Atlas O-72" curves. Have just one big loop going to the left. If I back it up, the rear truck of one of the units comes off the track & kicks the circuit breaker on. Also, on a couple of the curves in forward that rear truck comes partly off the track. Sounds like it might be riding on the flange & just drops back in. Has anyone else experienced this issue? Any suggestions for a fix? When I look at it after it goes off the track, almost looks like it might be hitting the side frame in front of it, but hard to tell. The other "A" unit runs perfectly fine. 

Thanks

 

 

Original Post

Replies sorted oldest to newest

I'm using the diaphrams that came with the engine. I ran them again in forward & watched closely where the problem was & it appeared the shell was riding on top of the truck & them dropped back down towards the end of the curve. My problem was even if I ran a single unit I had the same problem. The other unit ran flawlessly . Seems like that one unit needed a little more space between the truck & shell. Maybe it just needs a washer. Really sucks for a VL item to have that problem. 

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×