lionel lift bridge #213 [6-14167]

Charlie, if nobody has one then you might be able to make it.  It's made from ribbon strip cable and a connector on each end with some heat shrink.

Actually... it's the newer lift bridge. That controller is hard to come by. I think you can get away with a basic STDP switch On-Off-On

I haven't reversed engineered my 213 controller, but I believe it is a "momentary on - off - momentary on" switch. Normally, switch is in the off position. Pulling switch to one momentary on position will open bridge, pulling switch to other momentary on will close bridge.

Oops      Got my lift bridges crossed up.  Thanks for the correction Dave.

@DaveP posted:

Actually... it's the newer lift bridge. That controller is hard to come by. I think you can get away with a basic STDP switch On-Off-On

Well,  I sent the OP an e-mail thinking I knew what he wanted.  There are more than one type of cable to make the bridge work.  Power cable and those attached to the weights.  I thought he was looking for the ones that attached to the weights.  They are available.

The controller is not rare and is available.  It is the same as those used to control Lionel tubular switches.

Also if you have Lionel ASC’s they can control the bridge wirelessly with either CAB1, 1-L or Legacy 990.  You might also be able to use Lionel’s SC1or 2’s as well.