I have an MTH VO 1000 and a MTH GE EVO that both start at the same time when I turn either one on using the DCS remote for start up. Can anyone tell me how I can stop this from happening? It doesn't affect any of my other engines. Thanks!
Replies sorted oldest to newest
Do a factory reset on both of the engines, then add them back in one at a time. Problem solved. 
Wouldn't he just edit the address of one loco while the other is off the tracks?
Wouldn't he just edit the address of one loco while the other is off the tracks?
I think Barry is probably right, if the battery isn't charged, it could explain his issues.
good time to mention a BCR.
before you re-add it, make sure that it has a well-charged battery or you'll wind up right back where you started.
The other night at NJHiRailers, I tried adding my Texas Special F-3 to the system. During several tries it mysteriously dropped out of the system, and on other tries, it would change by itself to a different number. I removed the shell and found the original MTH battery was still installed. I replaced it with a new one and no more problems.
Phil
Access to this requires an OGR Forum Supporting Membership
