i have 2 older beeps [no female mu plugs ]rmt sent me 3 thethers[ male to male need female plugs [wons that come out from eng]
rmt ,s supposed tech people don,t know there parts very well NEED FEMALE connectors to go from eng to male to male to eng someone said called molex plug??? FRUSTRATED eng female plug male plug wire male to female to eng simple? HELP!
Replies sorted oldest to newest
I imagine you have to remove the shell and wire them to the pickup wiring? I installed teathers on all my early BEEPs - actually long before RMT brought out BEEPS with tethers, because they just would not go over switches smoothly. I bought some small connectors at Radio Shack - just a two-wire plug with wires on each end. It's been several years. don't remember the details but it was fairly straightfoward - remove the shell, connect the tether wires to the center and chassis-outer rail pickup wires, route the teather out under, and reattach the shell.
In case any Forum readers are confused...As older RMT BEEPs were not produced with any plugs -male or female, this request was a bit confusing.
Here is original email request...
i bought 3 units male to male {NEED FEMALE SIDE] so older beeps can be MU ed [electricly tied together ok
In reality, each new (or customer modified) BEEP will have 1 male on FRONT and 1 female on REAR of chassis to make MUing 2 BEEPs possible. RMT offers the molex plugs in a pair as a 'repair' part.
I am waiting for the customer to contact RMT by phone so this problem can be solved as it looks like a female plug was used on both ends of BEEP. This is not correct..
Thanks.
Walter M. Matuch/RMT
Access to this requires an OGR Forum Supporting Membership
