Needing a wiring diagram for the 10 pin wiring harness connector on an MTH Imperial 0-6-0 steam engine (on the engine itself) #30-1410-1 w/PS2. The wires on the rear of the PC board were fried and melted off and I have no idea what went where now. Have a new 10 pin PC board connector, just need to figure out where the wires go. Thanks in advance!
Replies sorted oldest to newest
Be careful basing it off of color. What they are used for is the best approach. While there is some standardization, MTH warns not to base it off wire color. G
Thanks for the replies. One concern I have is the in addition to the 10 contacts there was a separate strip on the PC board labeled PV on one point & K on the other. It looks like one of the purple wires or a light blue wire may have gone to that. Ideas? Thanks in advance!
Access to this requires an OGR Forum Supporting Membership
