Hi All,
Can someone help me out here. I have wired an MTH accessory to ACC1 of the Aiu and the accessory does get
enabled after I programed it into the remote. The problem is that when I add the 2nd accessory to the remote and
do not have any wiring to the Aiu etc, hitting the 'ON' soft key on the remote fro accessory 2 will enable accessory 1.
Any ideas on this?
Replies sorted oldest to newest
If the first accessory does, indeed, operate properly when the first entry in the remote is activated, then there are really only two possibilities:
Hi Barry,
Can you tell me how I may have programmed the 2nd accessory incorrectly? It is just a matter of giving the entry a name correct?
Thx - Al
Al,
It is just a matter of giving the entry a name correct?
It's more than that.
If you have more than 1 TIU, you must provide the TIU#.
In all cases, you must select:
Hi Barry,
i ONLY HAVE 1 TIU and 1 AIU. In any case I started from scratch meaning, removed all accessory entries in the AIU, rewired the connections and now it is working fine. Amazing starting from square 1 will do.
Thanks fro the replies I appreciate it.
Al
Access to this requires an OGR Forum Supporting Membership
