Skip to main content

I have two O Gauge floor loops using TMCC with a ZW 275W and two powermasters.  Right now both trains are running under conventional mode. Last night I started having a problem. No matter which track I address with the remote, it sends signals to both power masters. For example, when I cycle one train through F N R N F, both trains cycle at the same time. I see both red lights in the powermasters flickering when I do this.  When I try other functions, such as whistle or bell, both power masters show the red light flickering at the same time.

This setup was working just fine since mid November when I set it up under the Christmas tree. Then suddenly it started doing this. I'm hoping for ideas to get this resolved before I just hook the loops up directly to the ZW. I'd sure like the luxury of being able to move around the room and not be tied to the transformer.

I don't know if would make a difference but I did substitute a different ZW this morning but the problems continued.



Thank you



David

Original Post

Replies sorted oldest to newest

Solved. Taking the advice of GGG I thought I would just reprogram the powermasters. I did track 1. Then when I went to reset track 2 I discovered that the switch had been moved to prg instead of run. I have no clue how that happened. I'll blame my dog I guess. I did the program set process and I am back in business. Both trains are running fine.



Thanks for the idea of what to check GGG. I love the easy fixes.



David

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×