While laying track on my layout (which uses Fastrak, O tubular and O-27), the pins get loose and so do the ends of the sections. I have heard of this tool, but I have no idea where to get one. Any help?
Thanks!
Original Post
Replies sorted oldest to newest
Try MicroMark.
.....
Dennis
I have had some luck using a small needel noise pliers. Hold the track in one hand and place the pliers on each side and under the problem pin, then squeeze.
Be very careful not to change the shape of the track profile so it will make a smooth joint for your trains to run on.
Good luck.
Several small manufacturers make "track pliers" for this purpose. The one I have is a heavy-duty lineman's pliers with a nub stamped into one jaw and a slight recess in the other, so that when you clamp down with the pliers, it dimples the track. I'm afraid I can't give you a specific source or manufacturer, but you might try The Train Tender (www.ttender.com). Note that because of the different track cross-section, there are different tools for 0 gauge and 027.
A bunch of them.
Always remember when removing track pins drive the pin in deeper then pull out. This releases the crimp.
Charles Ro.
Behind the cashier counter. On the wall. About 12 bucks.
Or call them.
Originally Posted by Southwest Hiawatha:
The one I have is a heavy-duty lineman's pliers with a nub stamped into one jaw and a slight recess in the other, so that when you clamp down with the pliers, it dimples the track.
Before you purchase one, make sure it has the crimped "nibs" on the end of the jaws for pinching the rail pin in place. There are a lot of pliers out there for sale that does not have that handy feature.
Try Ebay search for Lionel track pliers. several available.
