Using DCS Remote with newer TIU

6.10 is the latest version of DCS and you don't have to  do any deleting on your remote.  Just make sure you don't add any engines into you phone or pad with the same address ID number. You probably should make a list of your engines with the address numbers to make sure this doesn't happen. You can change the engine address to be the same as the remote by using the menu/system/engine setup/edit engine/edit address

There is no need to change the TIU, the Wi-Fi will work fine with it.  My TIU is rev G and it works great.

Depending on how old the Wi-Fi unit is you may need to upgrade the firmware.  Before you install it, read the instruction book section under LUCI.  Use LUCI to check the firmware - you need ver 1.1 to work well with TIU ver 6.1.  You can download 1.1 from MTH.  Follow the instructions to install it (actual install time is 1 minute, give or take).

Your remote will work exactly the same as it has.  Using the app, your phone or tablet acts like another controller on the system.

Joe,

So you can have the same engine in the remote and Phone/PAD but you have to make sure the address is the same in both.  Which means you can run the same engine in either the remote or Phone/PAD, do I have this right?

Correct

Danr,

The reason I would like to change out the TIU is to make sure if works properly. With MTH going out of business I don't want to take any chances down the road when I do happen to have to use the newer TIU.

Dan,

God idea to test anything new to make sure it works, even if a company isn't closing.