I bought a DZ 1090 signal bridge for my layout - it looks amazing, but I can't get it to show green/proceed.
To test the unit, I connected the red and black wires to hot and common ports of a CW transformer - when I did so, the semaphores both moved to the 'red' stop position and stayed there. When I turned power off and on again, the semaphores rose to green, then returned to red again.
I tried the reset instructions (attaching all 5 wires to hot and turning power on) and this did not fix the issue (note that the semaphore did not go to yellow when I did this either).
Has anyone else had this issue or has any idea what I should try next?
