I have a KLine #45 caboose with no instructions. Came with small amount of smoke. Where do you add it?
Thank you.
Original Post
Replies sorted oldest to newest
Usually right down the stack where the smoke comes out. The small "T" piece at the top of the stack pulls off then add your fluid.
Thank you Chris.
Jack
Don't expect such great results. It needs quite a bit of power. When running your consist you may have to look hard. At idle you may have to crank up the power, Also at some point in time you may notice that your caboose has melted as well. At lease that all was my experience with such
Some of the KLine Cabooses have a switch on the bottom for conventional or command running. Make sure it is set to command if that is how your running. It will keep it from melting.
Be VERY careful with the K-Line smoking caboose. I've seen a few that were ruined by heat because the smoke unit got too hot.
Usually 4 to 8 drops for those smoke units. My SP Railroad Police Caboose was like that after I sold mine. Be careful certain smoke units have melted the plastic on the roof.
The two I have just have an on and off switch. I run mostly command so I leave them off. For the amount of smoke that comes out of them it's not worth a melt down.
This has been my experience with them::
Attachments
Images (1)
