Does anyone have the MTH part number for the 10-pin Proto2 passthrough teather for a dummy B unit? Rather not bug Midge if possible; she's pretty busy ... thanks
Original Post
Replies sorted oldest to newest
Thanks! That's what I needed.
There is a Tether that will do what you need I believe, let me look for the part #.
I haven't seen one of the new slave upgrade kits yet, but if the kit includes a tether with plugs at both ends, this would be a new part specific to the kits. I am afraid Midge would only have the magic number on these right now.
Here we go!
3-volt type) (520.0mm long) (w/10 pin male flat plug on one end) (w/10 pin female plug with
green board on the other end) (fits the entire length of the B-unit.
The part number for the above "B" unit wire harness is BC-2100070. The cost for this "B" unit wire harness is $18.00 each (for one).
Sounds good, but I thought you were looking for a harness with plugs at both ends. It sound like to me one end has the socket board at one end to mount to the truck, kinda like what I was describing.
This one is supposed to be the B-unit passthrough teather ... I need to get the signal from the Master board through the B units to the slave A on the other end of the ABBA consist. The kit comes with one B-unit teather, this will provide for the other.
