Skip to main content

This was also posted on the Lionel TMCC & Legacy Forum.

 

I recently prurchased a new Legacy remote and Cab 2 to add to my DCS layout.  Previously I had a command base and was able to run TMCC engines with the DCS or Cab 1 remote.  I hooked up the Legacy base following the schematic on page 124 of Barry's book (2nd edition) replacing the #50-1018 cable with the #50-1032 cable.  I am able to run TMCC engines with the Cab 1 or Cab 2 remotes but not with the DCS remote.  I do not have any problem controlling my DCS engines, switches and accessories using the DCS remote.  I have checked the programming numbers of the TMCC engines and they correspond exactly to the numbers in the DCS remote.  Any suggestions as to solving my problem?

 

Original Post

Replies sorted oldest to newest

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×