Commodore Reset

I believe you have to whisper, softly

 

"Is it me you're looking for?
I can see it in your eyes
I can see it in your smile
You're all I've ever wanted

Hello! "

 

Farmer Bill,

??

Thanks for the help.

Oh, so sorry, that was a different Lionel in the Commodores.

You might want to try program code 74 to do a re set.  That is the code for the black Commodore..

 

Marty

George, like Martin said you could try code 74.  I have an older list and it shows a select few as using code 47.  This includes the darker CV, which is the one I have.

 

Either one, it won't hurt.

If you have no sounds at all, it is possible you have a bad volume switch...

 

Marty

Marty,

 

That was the number!  All TMCC functions and sounds are back.

 

Thanks,

 

George

The LCRU, generation 1 has some wires on the right of the PCB that, depending on how they are wired, configures the various outputs. So, no, there is no auxiliary program code for the following TMCC locos: Com vand. (Original issue silver) Wabash Hudson (blue) Boston and Albany Hudson from 1995/96 Rip grande sd50 with horn After these locos the LCRU'a were generation 2, where a programmable auxiliary code controls the outputs. The codes are still: 4 = front light always on / smoke on / off (steam) 5 = strobe light on / off 6 = cab light on / off (press and hold 9 and output stays at 12v) 8 = smoke on / off (press and hold 9 and power is boosted to 14v, let off 9 power goes to 12v for smoke unit) Hope this helps clear the air! Mike