I installed two WTIUs on my layout this afternoon... I had one problem with one of them because there was a short from derailed cars and engines on the tracks it controls... I had to remove most of the engines and cars until the short cleared; then I was able to restart this WTIU and add engines and start them up... The second WTIU worked from the start...
But during my troubleshooting I developed some questions... I realized at one point that each WTIU had the same address or so I thought.. I noticed that there is no blinking light on the WTIU to indicate its address..
How do you determine the actual WTIU address with the App?
When I used the TIU address command and tapped edit it only showed 3, 4, 5 as available... 1 and 2 were nowhere to be seen... So I edited the addresses of the WTIUs to 3 and 4 respectively... Leads to second question:
Why were addresses 1 and 2 not available? Will resetting each WTIU to factory defaults bring them back? [Currently I don't have much data in each WTIU so that's not a problem]
Thanks in advance for any tips anyone can provide..
