Happy Fourth to all!!!
Can anyone tell me the correct size to order for wire plug connectors used on the PS 2 boards? I know they're NOT .100 pitch, (AKA 2.54mm), but I do suspect they're in the 2.50mm or 2.40mm area. I made myself a bench tester from a PS 2 wiring harness, now, I want to use that harness in a loco, but I still want the test fixture. Kinda like wanting your cake and eat it too [wink!]
Thanks,
Joe
Replies sorted oldest to newest
3V type are in the Digikey 2011 catalog page 137 Tyco/ AMP 2.0mm HPI Connectors.
5V type are Hirose DF3 product line in 2mm spacing. Mouser catalog page 1610.
BC-1000008 - Wire (22 gauge)
BC-1000009 - Wire (28 gauge)
Wonderful!!!!!!!!!!!!! Thank you GRJ!!!!!!!!!!
Best Regards,
Joe
Good luck on finding the contacts as it seems the industry has been out of them for the last few years.
Ha,ha, now that makes sense!!! Thanks for the heads-up!
Best,
Joe
3V connectors are actually Chyao Shiunn JS Series. But other connector brands are similar enough to use. Hirose contacts will work in the CS connector too. G
Thanks G!!! I found a good contact in China, that may be able to help with a lot of these parts. I'll keep you guys posted, if this pans out. I've already bought some of the components that don't show up here with exact cross of numbers. Still haven't made that much progress, but a little, is better than none at all!!! Thanks for all the contributions of info!
Best,
Joe
Here's the pins for the PS/2 3V connectors at Digikey: SWT201-UPTN-S01-UU-UU
GREAT GRJ!!!!!!!!!! AsALWAYS, thank you!!!
Best,
Joe
Access to this requires an OGR Forum Supporting Membership
