Correction of factory error in assembly of Strasburg Observation cars, with wash closet at observation end. Disassemble the car removing both end caps. Unplug power feed from overhead light circuit board. Note that the current routing of power feed is in the open and should be behind the wall or in closet at other end of floor. The power feed is glued in place on the underside of the floor wires must be cut and new wires solder to switch and run the opposite way down the floor, splice them to the plug end from where you cut them now reverse the floor and reassemble the car place the power feed behind the wall or I closet. Hope this helps. Once completed vou will have two beautiful cars.
Attachments
Images (8)
Original Post
