Happy Holidays to all and to all a good train day. Replaced thumb wheel in DCS remote now down is up, thought I was maybe little dyslexic might work better.
Original Post
Replies sorted oldest to newest
There are two wires that need to be swapped, apparently the color codes aren't consistent. When I take one out, I note which connection on the thumbwheel goes to which main board connection and ignore the wire colors.
This came with the last one I bought.
Attachments
Yep, but some of them had the wrong colors for the wires. 
Do you mean no red, green, or yellow?
I believe they were in the wrong order. I can't find the post about it, maybe @GGG remembers the details.
That's what the bulletin described. The one I took out was not the same order, so the factory switched a couple wires. The thumbwheel ended up working the right way with the new instructions.
Thanks John, I knew there was a switch, but I haven't been bit by it yet. 
I hooked it up like the diagram in the post what is the new order according to the bulletin ?
Hi, you just roll the outer wires on the wheel, and it will work perfectly I remember when the replacements came out!
Alan
@Alan Mancus posted:Hi, you just roll the outer wires on the wheel,
It's not a spool.
So switch the green and the red
