Early PS 2 Help Needed stuck in neutral

Does it run with your Z-4000 in conventional?  If this engine has not been factory reset with a Full DCS system it will not run on the DCS Remote commander.

While the battery has been charged, if it is bad it still will not come out of neutral.  Power it up with the Z-4000 and then turn power off. Do shut down sounds play for 5-8 seconds.   G

Ok no it will not run with the Z4000 and no shut down sounds do not play when power is turned off.

Ok where is a good source BCRs the 8v and the 3v? At a good price.

https://mthtrains.com/sites/de...tion/30rtr17516i.pdf

above is the document which will tell you how to reset the engine read page 12 and below it explains  how to reset it back to original!

Thanks

let us know how you make out!

His battery is dead, so no joy until that is replaced.  G

BCR:   www.jandwelectronics.com

Thanks for the info. Up date put a 9v battery in and it runs great. Had to go and get battery at the store.  Now I have a PS2 Diesel switcher that was doing the same thing so I need to get the BCRs for both.