Skip to main content

Replies sorted oldest to newest

At the suggestion of those who use these trestles, I secured the top metal bracket with sheet metal screws.

 

I wasn't sure what size would work so I bought a boxed assortment of screws from Harbor Freight (Part Number 92710). 

 

Do not overtighten to avoid seperating the brown post.

 

If the post does seperate you can use a small ty-wrap to hold the post halves together.

 

IMG_3486 [Small)

IMG_3485 [Small)

 

P.S.  I have since taken down my trestles as I found them to be a bit unstable and was nervous about an engine falling off and causing damage. 

Attachments

Images (2)
  • IMG_3486 (Small)
  • IMG_3485 (Small)

I have the graduated set and the elevated set on my lay out.  Once I put everything together it seems to be working out fine.  I did have problems with one or two.  But I got them straightened out now.  At first I cut out 1" blocks of wood and put under each base. Because one of the guys at the one Hobby Shop I deal with told me to put the extra elevation on them to start with before I find out I need it after I have my lay out up and running.  Well, just the opposite happened!!!!  I had to remove all of the blocks I put under the bases because the elevation was TOO much!!!!   I had to reposition one of the bases because it would interfere with one of my switch tracks.  But other than that everything runs fine.  What I did do, I put up a safety fence all the way around my lay out to prevent anything from falling off onto the floor. So if I have a derailment or one goes flying off the track; it's not going on the floor!!!

I did NOT screw down the bases on my trestles because my layout is on a rug over a folding table and there's no way to screw the bases down without damaging the tables.

I did use the connecting rods except where I had to 'scrimp' a bit and the rods were too long.

Most of the trestles/tracks were on the very edge of the table and the whole setup was inviting disaster if I de-railed.

I found that I needed lots of 'real estate' in order to ramp up to full height and then ramp down to return to the table top.  I used a lot of full height trestles between the ramp up/down trestles.

 

Tom

Post
×
×
×
×
Link copied to your clipboard.
×
×