I want to conect a pair of RH and LH switches in parralel with one controller. The problem is that I'm using them as a crossover from one track to another and when one is straight the other is curved. So on the second switch reversing the red and green wires should get that result?
Replies sorted oldest to newest
Yes
Thanks, just wanted confirmation before hand.
Well, I finally got my layout set up with a double crossover between two main lines and the one crossover using 2 RH 036 switches works great wired to a single controller, but the other pair is a problem. One is LH and the other RH and when I want to across over the LH switch must be curved and the RH straight, but I can't make it work that way with one controller. I've tried reversing the green and red wires, but no luck. I'm open to ideas.
When reversing the red and green wires, you only did that on ONE switch in the pair, not both, right?
Anywyas, here is a thread with details: https://ogrforum.com/...hers-with-one-switch
bmoran4 posted:When reversing the red and green wires, you only did that on ONE switch in the pair, not both, right?
Anywyas, here is a thread with details: https://ogrforum.com/...hers-with-one-switch
Yes, I reversed the the green to the Out terminal and the red to the Thru on the LH switch. Could the problem be that the LH is a 6-12045 and the RH is a 6-81926 command?
OK, all is well. In checking, I found my temporary wiring was faulty.
Access to this requires an OGR Forum Supporting Membership
