I finally had a ground plane problem while setting up my Milwaukee Road 261 for the show this Sat and Sun at Fox Run in Novi, MI. I had just updated to 1.52 and had the engine on the table to check out 1.52 and the engine would sometimes not respond to commands. To check out the new Veranda I had the floor loop powered with DCS and Legacy signals. You can guess what - when I disconected the Legacy signal to the floor loop the MR 261 ran as expected. The floor loop in 29" below the table top and runs parallel to it. Looks like the Legacy signal is very strong. Problems pop up in the stranges places!!!
Original Post