Harley Davidson SD60 non responsive. Ideas?

If the 5V version it could be that it died. But lights are on?  G

You ought to post the model number.

You could try a conventional reset:  No DCS signal on tracks.  Using transformer, press whistle once and bell 5 times, at half-seconf intervals.  If it takes, loco will respond with 2 toots.  If not, try again a few times.  Timing is critical.

Would not load on the DCS at the show and now is not tecognized by my DCS at home.

If it's still in the remote delete it and try adding again.....Yep use a programming or test track... Having the engine light up is not a good sign... It should remain dark & silent upon powering up the TIU and  track.(watch dog)

Maybe even try the recover engine feature.

RJR posted:

You ought to post the model number.

You could try a conventional reset:  No DCS signal on tracks.  Using transformer, press whistle once and bell 5 times, at half-seconf intervals.  If it takes, loco will respond with 2 toots.  If not, try again a few times.  Timing is critical.

Please forgive my terrible mistake in not posting the part number. The number I have is 20-2595-1.  I tried the reset about ten times with no response. I deleted the engine and it would not load again into the DCS. I also tried the engine recovery in DCS with no luck. Timing is bad on this since this is not in my budget for another whole new board.

So, I assume this is now a shelf queen? What are the costs to fix?

If you do it the cost of a PS-3 Upgrade kit. G

GGG posted:

If you do it the cost of a PS-3 Upgrade kit. G

I have done TMCC but never PS3 kits so how much of a bear is it?

Retail on the PS3 board with speaker and stacker boards is like $235 as the direct replacement for the 5 volt set. You won't have to rewire it just install the new speaker and plug in the boards.