Skip to main content

Aftre chasing an intermittent issue where the locomotive just stops dead, I have traced the issue to the harness that the drawbar plugs in to on the locomotive. It is six pins on each end and is about 5 inches long. It plugs in the board between the two drive motors and goes out the back to the drawbar mount. On the Triplex the draw bar is fixed to the tender and plugs into the locomotive. I can not find the harness at MTH. Anyone have one or a source where I could find one?

Original Post

Add Reply

Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×