How to activate MTH Proto 2 Subway Announcements

Arnold D. CribariOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

I have a used MTH Proto 2 subway that I purchased from a LHS without any box or instructions. It's red in color and says it's the number 4 Lexington Ave. Woodlawn Express. I only run conventional using the MTH Z4000 transformer.

How does one activate the station announcements for this Proto 2 subway so it automatically stops, makes the announcements and starts us again?

I have a Proto 1 subway (the one that says Yankee Stadium 161st Street), and by pressing the bell button for a few seconds and then releasing it, the subway automatically stops, ann po ounces and starts up again. When I did this for the red Proto 2 subway, it didn't do that automatic sequence but otherwise works fine.

Arnold

12/13/208:17 AM

❤️ 0

Original Post

Replies sorted oldest to newest

Arnold D. CribariOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

I think I figured it out. For MTH Proto 2 subways, to get the train to automatically stop, announce and start again, you press the bell button for a few seconds, release it and then press the directional button so it stops. Then, it will automatically announce and start up again. Arnold

12/13/209:05 AM

❤️ 0

Oscale_Trains_Lover_OGR Forum Member SUPPORTING MEMBER

Arnold,
To activate the Transit Announcement Sounds (TAS) on PS2 subways, you need to press the bell button for ~2 seconds. Since you said that you do not have a manual, here is a pdf of a Railking PS2 subway manual from the MTH website: https://www.mthtrains.com/site...tion/30rtr19065i.pdf

If you look on page on page 6, there is a table that shows all of the commands for PS2 subway sets when in conventional mode. I hope this helps! thumb

Bryce

12/13/209:08 AM

❤️ 0

Oscale_Trains_Lover_OGR Forum Member SUPPORTING MEMBER

@Arnold D. Cribari posted:
I think I figured it out. For MTH Proto 2 subways, to get the train to automatically stop, announce and start again, you press the bell button for a few seconds, release it and then press the directional button so it stops. Then, it will automatically announce and start up again. Arnold

Arnold,
Glad you figured it out! I was writing a response to you at the same time, haha!
Bryce

12/13/209:09 AM

❤️ 0

Arnold D. CribariOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

Here's photos of it: