Skip to main content

Hello,

I am looking for some help. I have converted a Kline GG1 to TMCC using the offered K Line kit that had all the required boards and wiring available at the time. The engine runs great now in TMCC mode but when I try it in conventional is just  sits there with the head lamp flickering. It should start up with sound and remain in neutral once it confirms there is no TMCC signal. If I place the PGM RUN switch into PGM while in conventional mode it moves forward immediately and will then do that even if the switch is placed back to run. Will then only move forward in Conventional. If I perform a reset the engine is still fine in TMCC but back to nothing but flickering headlamp once conventional is tried again. Any help on why it does not work in conventional is greatly appreciated.

Dave

Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×